2.7inch E-Ink display HAT for Raspberry Pi, three-color


E-Ink (Electronic Ink) display has several benefits compared to other display technologies:

  • High Visibility and Contrast
  • Wide viewing angle
  • and super low power consumption. It can retain the display for a very long time after power is removed

This is an E-Ink display HAT for Raspberry Pi, 2.7inch, 264×176 resolution, with embedded controller, communicating via SPI interface, supports red, black, and white three-color display. Due to the advantages like ultra-low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf labels, industrial instruments, and so on.




  • No backlight keeps displaying last content for a long time even when power down
  • Ultra-low power consumption, basically power is only required for refreshing
  • Compatible with:
    • Raspberry Pi 4 Model B
    • Raspberry Pi 3B+
    • Raspberry Pi 3B
    • Raspberry Pi Zero WH
    • Raspberry Pi Zero W
    • Raspberry Pi Zero
  • Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
  • SPI interface, for connecting with other controller boards like Raspberry/Arduino/Nucleo, etc.
  • Onboard voltage translator, compatible with 3.3V/5V MCUs
  • Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
  • Stack perfectly on Raspberry Pi 4B/3B/3B+ via the 40-pin GPIO header.


  • Operating voltage: 3.3V/5V
  • Interface: 3-wire SPI, 4-wire SPI
  • Outline dimension: 73.50 × 56mm
  • Display size: 57.288mm × 38.192mm
  • Dot pitch: 0.217 × 0.217
  • Resolution: 264 × 176 pixels
  • Display color: red, black, white
  • Grey level: 2
  • Full refresh time: 15s
  • Refresh power: 26.4mW(typ.)
  • Standby Current:  less than 0.01uA (almost none)
  • Standby power: 170°

Packing List

  • 1 x 2.7inch E-Ink display HAT (3 colors) board
  • 1 x 8-way JST plug to pigtail jumper wire (female socket terminated)
  • 4 x 15mm spacer (2.00 mm diameter) with screws and nuts



There are no reviews yet.

Be the first to review “2.7inch E-Ink display HAT for Raspberry Pi, three-color”

Your email address will not be published. Required fields are marked *


Your Cart is Empty

Back To Shop